High misalignment GTR/Z32 タイロッドエンド

Only 3 Left

Q: What is backorder?
When a product is on backorder, it means that we have sold out and we are opening a back order due to popular demand. This is essentially a queue, when new stock arrives from production, we’ll send your order.


Q: How long does backorder take?
An ETA isn’t currently set as we are working with production to confirm an ETA. We will normally have this confirmed within 5 days so please check back shortly.

*In the event of unforeseen delay from production or shipment arrival, we will do our best to let you know


Q: Will items in my order that are in stock be shipped out first?
We will send your order altogether once your backorder item is ready! You may wish to place separate orders if you want an item before the other is due back in stock.

¥16,800

The GKTECH high misalignment tie rods have 64 degrees of misalignment and also up to 25mm of bump steer correction built in. 

Although these may look pretty similar to other tie rod ends on the market, don't be fooled as they are different (in a good way). Almost all tie rod ends on the market that use rose joints are NOT using high misalignment bearings and wear out in no time at all. OEM type tie rod ends provide around 60 degrees of misalignment and it is critical that around this level of misalignment is kept. Another common issue with most aftermarket style tie rod ends is that there is no protection from dust and dirt. We've developed dust boots specifically to suit the PCYML10T rose joints that we use in our kit. It's also pretty common for shanks to bend under high loads, our shanks have a tensile strength of 176ksi (class 12.9)

Bump steer correction is altered through the use of 5mm shims. 

- Corrects bump steer up to 25mm 
- Uses high quality PTFE lined 1 5/8" high misalignment rose joints 
- Dust boots included 

Vehicle Compatibility:
- Nissan Skyline R32 GTS-4
- Nissan Skyline R32 GTR
- Nissan Skyline R33 GTR 
- Nissan Skyline R34 GTR 
- Nissan 300ZX Z32
- Nissan Stagea

NOTE: These tie rod ends are only to suit OEM knuckles or knuckles that use an OEM taper.

NOTE#2: If you have the Gktech Super lock R/Z chassis knuckles these tie rod ends will not fit.
You would need these: https://jp.gktech.com/high-misalignment-64-degrees-tie-rod-ends-12mm-14mm

description

.

FAQ's

How hard are these to install?
Remove your old tie rod ends and install these. It's a very self explanatory install and shouldn't take longer than 30 minutes.

Will this fit my car?
If your car is listed above then this is a straight fit.

Do I need a wheel alignment after installing these?
Unless you get the length spot on perfect, you will need a wheel alignment after installation.

Copyright © 2007 - 2020 Geskin International Pty. Ltd. T/as GKTECH. All Rights Reserved.